Bradford White Water Heater RG2PV40T6N19

Position gas control power switch to 'OFF' position and adjust control to call for heat.

Unplug blower power cord from wall outlet.

Disconnect vent system from exhaust adapter on top of blower.

Remove exhaust adapter from blower using a blade screwdriver and retain for use on new blower.

Remove the three blower mounting screws using a 1/4” nut driver.

Remove blower with gasket from water heater.

Position power switch on gas control to the “OFF” position

Remove the three screws from control access cover on blower assembly and remove cover

Remove pressure switch from blower housing

Resume operation following the lighting instructions

Use caution to avoid personal injury due to 115 volt potential exposure

Ensure safety precautions are in place

Remove three screws from control access cover on blower using a Phillips screwdriver

Remove control access cover from blower

Use special pin type electronic probes or small diameter wire pins inserted into connector

Insert one meter probe into center wire position of temperature sensor connector

Insert the second probe into either of the outside wire positions

Alternate the probe on the outside position to the opposite outside wire position

Has the control gone into lockout due to excessive tank temperature?

Reset control by sliding gas control knob to 'OFF' position and wait a minimum of 5 minutes

Follow lighting instructions and return gas control knob to desired setpoint

Observe Green LED indication. Does error code 4 continue?

SECTION: Inner Door Removal Procedure

1. Position gas control power switch to the “OFF” position.

2. Remove outer jacket burner access door.

a. Remove (2) ¼” hex drive screws from right side inner door.

b. Remove (2) ¼” drive screws from flange section of inner door.

c. Remove (2) ¼” drive screws from left side inner door.

d. Remove inner door and inspect per step 4.

4. Fully inspect inner door gaskets for the following: Tears, Missing Material, Cracks, Dirt or debris, Other imperfections that will inhibit proper seal, Gasket adhesion to inner door, Material left on combustion chamber (around opening).