Bradford White Water Heater RG1PV40S6X19

Inspect the pilot burner for proper operation and debris accumulation.

Check if the pilot flame is stable.

Identify causes for an unstable pilot flame, if applicable.

Ensure the main burner lights smoothly from the pilot.

Verify the main burner burns with a blue flame with minimal yellow tips.

Check the main burner for any debris accumulation that may affect operation.

Position gas control power switch to 'OFF' position

Remove the three screws from control access cover on blower assembly and remove cover

Remove pressure switch from blower housing by removing the two T10 screws or carefully remove it from the housing if it does not have screws

Disconnect tubing from pressure switch

Disconnect yellow wires from pressure switch

Reconnect yellow wires to new pressure switch

Reconnect tubing to new pressure switch

Carefully position pressure switch into blower housing

Ensure safety precautions are followed

Position gas control power switch to 'ON' position and adjust control to call for heat

Remove the three screws from control access cover on blower assembly using a Phillip’s screw driver

Refer to photo 7 for guidance on removing the cover

Position on/off switch of gas control valve to the “OFF” position and unplug water heater from wall outlet.

Turn off cold water supply to water heater.

Disconnect outlet nipple from plumbing system.

Remove outlet nipple/anode from the water heater using an appropriate tool such as a pipe wrench.

Visually inspect outlet nipple/anode for signs of depletion.

Is the depletion ½ of the original anode diameter or is any steel core exposed?

Reinstall outlet nipple/anode into water heater using pipe dope on the nipple’s threads.

Connect nipple to plumbing system, resume water supply and refill with water.

Pilot Inspection, Testing and Replacement

Position gas control power switch to the “OFF” position and unplug heater from wall outlet.

Turn off gas supply to water heater.

Remove outer jacket door and inner door per service procedure XIII on page 39.

Disconnect pilot tubing nut (7/16” wrench) and feedline nut (3/4” wrench) from gas control.

Disconnect igniter/flame sense wire from gas control.

Remove burner assembly from combustion chamber.

Remove pilot assembly from feedline (1/4” nut driver).

Visually inspect igniter/flame sense wire for damage. Replace pilot if damage is found.