Xylem Pump 22SV4FA1A10

Is the lubrication frequency increased due to elevated temperatures?

Ensure not to intermix grease bases (lithium, sodium, etc.)

Completely purge old grease if changing grease base

Avoid over greasing to prevent excessive bearing temperatures and failures

Start-Up — Wiring and Grounding

Install, ground, and wire according to local and National Electrical Code requirements.

Install an all leg disconnect switch near pump.

Disconnect and lockout electrical power before installing or servicing pump.

Does the electrical supply match the pump's nameplate specifications?

Use only stranded copper wire to motor and ground.

Ensure wire size limits maximum voltage drop to 10% of motor nameplate voltage.

Ensure ground wire is at least as large as wires to the motor.

Color code wires for ease of maintenance.

Remove the motor following steps 1 through 4 in the MECHANICAL SEAL REPLACEMENT section

For motor frames 213TC and larger, remove the 4 motor hex cap screws and the motor adapter

Install the motor adapter flange onto the new motor

Torque the 4 hex cap screws to the values provided in the ENGINEERING DATA section

Complete the reassembly following steps 17 through 22 in the MECHANICAL SEAL REPLACEMENT section

Ensure all additional unit service or maintenance is performed at a qualified service location

Contact your local dealer or Goulds Water Technology distributor for assistance if needed

Recommended Motor Bearing Lubrication Intervals

Ensure not to intermix grease bases (lithium, sodium, etc.)

Completely purge old grease if changing grease base

Check for signs of over greasing to prevent excessive bearing temperatures and failures

Ensure pump is not inactive in freezing conditions

Has suitable antifreeze been added to the water?

Ensure drained liquid does not cause damage or injuries