Xylem Pump 1SV4CA1A10

Check motor operating conditions

Is the motor operating at elevated temperatures?

Increase lubrication frequency if operating at elevated temperatures

Is the current grease base lithium or sodium?

Completely purge old grease if changing grease base

Ensure not to over grease to avoid excessive bearing temperatures

Refer to driver and coupling manufacturers

Store in a covered dry location

Recommended Motor Bearing Lubrication Intervals

Ensure not to intermix grease bases (lithium, sodium, etc.)

Completely purge old grease if changing grease base

Check for signs of over greasing that can cause excessive bearing temperatures, lubricant and bearing failure

Drain the pump through the drain plugs if inactive in freezing conditions

Ensure drained liquid does not cause damage or injuries

Remove the motor following steps 1 through 4 in the Mechanical Seal Replacement section

Remove motor hex cap screws and motor adapter for frames 213TC and larger

Install motor adapter flange onto the new motor

Torque the 4 hex cap screws to specified values in the Engineering Data section

Complete reassembly following steps 17 through 22 in the Mechanical Seal Replacement section

Note any additional unit service or maintenance required

Contact local dealer or Goulds Water Technology distributor for assistance if needed