Xylem Pump 22SV4CA1A10

Remove the motor following steps 1 through 4 in the MECHANICAL SEAL REPLACEMENT section

For motor frames 213TC and larger, remove the motor hex cap screws and motor adapter

Install the motor adapter flange onto the new motor

Torque the 4 hex cap screws to the specified values in the ENGINEERING DATA section

Complete the reassembly following steps 17 through 22 in the MECHANICAL SEAL REPLACEMENT section

Note any additional unit service or maintenance required

Contact local dealer or Goulds Water Technology distributor for assistance if needed

Refer to driver and coupling manufacturers

Store in a covered dry location

Is the motor operating at elevated temperatures?

Increase lubrication frequency if operating at elevated temperatures

Is the grease base being changed?

Completely purge old grease if changing grease base

Ensure not to intermix grease bases (lithium, sodium, etc.)

Avoid over greasing to prevent excessive bearing temperatures and failures

Check motor operating conditions

Is the motor operating at elevated temperatures?

Ensure not to intermix grease bases (lithium, sodium, etc.)

Completely purge old grease if changing grease base

Avoid over greasing to prevent excessive bearing temperatures and failures

Recommended Motor Bearing Lubrication Intervals

Are lubricants operated at elevated temperatures?

Increase lubrication frequency if lubricants are operated at elevated temperatures

Ensure not to intermix grease bases (lithium, sodium, etc.)

Completely purge old grease if changing grease base

Is there any sign of over greasing?

Check for excessive bearing temperatures, lubricant and bearing failure due to over greasing