Xylem Pump 10SV4FA1A10

Ensure pump is inactive before draining

Drain the pump through the drain plugs

Has suitable antifreeze been added to the water?

Describe any damage or injuries caused by the drained liquid

Remove the motor following steps 1 through 4 in the MECHANICAL SEAL REPLACEMENT section

For motor frames 213TC and larger, remove components

Install the motor adapter flange onto the new motor

Torque the 4 hex cap screws to the specified values in the ENGINEERING DATA section

Complete the reassembly following steps 17 through 22 in the MECHANICAL SEAL REPLACEMENT section

Note any additional unit service or maintenance required

Contact local dealer or Goulds Water Technology distributor for assistance if needed

Start-Up — Wiring and Grounding

Install, ground, and wire according to local and National Electrical Code requirements.

Install an all leg disconnect switch near pump.

Disconnect and lockout electrical power before installing or servicing pump.

Verify electrical supply matches pump's nameplate specifications.

Ensure wire size limits maximum voltage drop to 10% of motor nameplate voltage.

Verify ground wire is at least as large as wires to the motor.

Ensure wires are color coded for ease of maintenance.

Check three phase motors for all leg protection with properly sized magnetic starters and thermal overloads.

MOTOR LUBRICATION — Recommended Motor Bearing Lubrication Intervals

Determine if lubricants are operated at elevated temperatures

Ensure not to intermix grease bases

Purge old grease completely if changing grease base

Avoid over greasing to prevent excessive bearing temperatures

Recommended Motor Bearing Lubrication Intervals

Are lubricants operated at elevated temperatures?

Is the lubrication frequency increased due to elevated temperatures?

Ensure not to intermix grease bases (lithium, sodium, etc.)

Completely purge old grease if changing grease base

Check for over greasing to prevent excessive bearing temperatures, lubricant and bearing failure