Welch Allyn Spot Vital Signs Device 4400

Verify the audio tone, especially at startup

Verify the touchscreen alignment

Disconnect the AC power cord from the mains outlet and the power source.

Ensure the device is powered down.

Remove battery pack from the device.

Dry off excess liquid from the device.

Did liquids possibly enter the device?

Remove the device from use until it has been properly dried, inspected, and tested by qualified service personnel.

Device and Accessories Cleaning

Inspect the following components for wear and faulty operation

Are there any signs of damage on the device?

Ensure the device is not used if there are signs of damage

Have qualified service personnel check any damaged device before putting it back into operation

Perform basic functional verification for the following modules

Complete Functional Verification and Calibration

Does the device meet specifications based on the basic functional verification?

Has the device been dropped or otherwise damaged?

Has an internal part been replaced (battery excluded)?

Perform complete functional verification and calibration if any of the above conditions are met

Inspect the device for any damage or contamination

Is the documentation for the current revision of the device available?

Are there any signs of damage or contamination?

Describe any issues found during inspection

Have you updated settings, replaced items, or called for service as necessary?