Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.

Documents & Manuals

Find all the essential guides in one place.

Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more

Work Order Templates

Pre-built workflows to keep your asset running smoothly.

Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more

Procedures

Integrate maintenance plans directly into your work orders.

Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more

Parts

Access the parts list for your equipment in MaintainX.

Drive Motor
B2 Rollers
Tensioning System
+ 40 more

Viking Pump K4124A

Create an account to install this asset package.

Maintenance Plans for Viking Pump Model K4124A

Integrate maintenance plans directly into your work orders in MaintainX.

Initial 100 Hours Viking Reducer Oil Change

Oil Type Selection

Select the oil type based on temperature conditions

Oil Quantity Verification

Verify the oil quantity for each size

Oil Change Procedure

Drain the old oil from the reducer

Refill with the new lubricant to the proper level

Post-Change Verification

Is the oil filled to the proper level for the selected size?

Run this procedure

1000 Hourly Ammonia Pump Reservoir Oil Change

Preparation

Ensure the pump is turned off and isolated from the power supply

Gather necessary tools and materials, including Light Refrigeration Oil and a container for old oil

Draining Old Oil

Check if the reservoir is empty before draining

Place a container under the reservoir to catch old oil

Open the drain plug and allow the old oil to completely drain out

Refilling Reservoir

Measure one pint of Light Refrigeration Oil

Run this procedure

Initial 200 Hours Ammonia Pump Reservoir Oil Change

Preparation

Ensure the pump is turned off and isolated from the power source.

Gather necessary tools and materials, including Light Refrigeration Oil and a container for old oil.

Draining Old Oil

Check if the reservoir is empty before starting the procedure.

Place a container under the reservoir to catch the old oil.

Open the drain plug and allow the old oil to completely drain out.

Refilling with New Oil

Close the drain plug securely after draining the old oil.

Run this procedure

Pump Alignment Check

CHECK ALIGNMENT AFTER MOUNTING

Recheck alignment after the pump unit is installed

Check pump ports to ensure they are square and in the proper position

Ensure piping is not forced to line up with the ports

Flexible Coupling Alignment Check

Remove any coupling guards or covers

Check alignment of the coupling halves using a straightedge across the coupling

V-Belt Alignment Check

Check alignment using a long straightedge or tightly drawn string across the face of the sheaves

Run this procedure

Thrust Bearing Adjustment

Initial Adjustment

Loosen the two set screws in the outer face of the bearing housing

Rotate the bearing housing in a clockwise direction until it cannot be turned any more

Marking for Alignment

Make a mark on the outside diameter of the bearing housing and a corresponding mark on the pump bracket

Make another mark on the pump bracket per 'Table 4' on page 14

Final Adjustment

Rotate the bearing housing in a counter clockwise direction until the mark on the outside diameter of the bearing housing lines up with the second mark on the pump bracket

Check end clearance with feeler gauge between idler and rotor faces, if possible

Run this procedure