True Food Service Equipment Refrigeration Equipment TDR48-RISZ1-L-B-SG

Ensure no pressure washer or hose is used for cleaning.

Wear eye protection to avoid injury from sharp fins.

Remove the screw securing the louvered grill to the cabinet.

Pull on the grill assembly to release it from the magnetic brackets.

Unplug the refrigerator/freezer before cleaning or making any repairs.

Ensure temperature controls are set to the 0 position or powered off.

Replace component parts with OEM components

Was a licensed service provider used for servicing the unit?

Ensure no power is present in light circuits, perimeter heaters, and evaporator fans.

Verify the operator's health and safety measures are in place.

Insert the master key into the lock cylinder

Turn the key and pull to remove the cylinder from the lock barrel

Slide the lock cam/bar out of the bottom of the lock barrel

Slide the lock cam/bar into the bottom of the lock barrel

Push the lock cylinder with master key into the lock barrel

Ensure the pin of the back of the lock cylinder aligns with the notch in the lock cam/bar

Shut-off the CO₂ at the regulator

Remove the tapping device (keg coupler) from the keg

Unscrew the handle from the faucet

Remove the beer faucet with the spanner wrench (turn clockwise)

Put the tap and faucet parts in a bucket

Add 1/2 oz. (14.2 g) of cleaning solution to each quart of warm water

Ensure the side latch is not used before removing the slide door.

Verify the tension on the door cord is intact.

Position the doors as described below

Lift the positioned door and tilt the top back until the rollers exit the door channel.

Swing the bottom of the door out of the bottom channel.

Remove the door cord from the roller bracket.