Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.

Documents & Manuals

Find all the essential guides in one place.

Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more

Work Order Templates

Pre-built workflows to keep your asset running smoothly.

Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more

Procedures

Integrate maintenance plans directly into your work orders.

Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more

Parts

Access the parts list for your equipment in MaintainX.

Drive Motor
B2 Rollers
Tensioning System
+ 40 more

Sullair Industrial Air Compressor TSR-20_125H

Create an account to install this asset package.

Maintenance Plans for Sullair Industrial Air Compressor Model TSR-20_125H

Integrate maintenance plans directly into your work orders in MaintainX.

1 Yearly Air Filter Replacement

Air filter maintenance on air filter no. 02250140-798 should be performed when the SupervisorTM displays Air Filter Maint, or once a year, whichever comes first. If the filter needs to be replaced, order replacement element no. 02250135 - 150.

AIR FILTER ELEMENT REMOVAL

Clean exterior of air filter housing.

Release the three retaining clamps and remove the end cap.

Remove element and clean interior of housing using a damp cloth.

Sign off on the air filter replacement

Run this procedure

1 Yearly Separator Replacement

SEPARATOR MAINTENANCE

Replace the separator elements when shown by the SupervisorTM Controller indications, or after one year, whichever comes first.

The separator elements must be replaced. DO NOT attempt to clean and reinstall the separator elements.

SEPARATOR ELEMENT REPLACEMENT

The separator elements must be changed when indicated by the SupervisorTM Controller or once a year, whichever occurs first.

CAUTION! Relieve all pressure from the receiver tank and all compressor lines.

Disconnect all piping connected to the separator cover to allow removal (return lines, service lines, etc.)

Loosen and remove the twelve (12) 3⁄4” x 2-1/2” GR5 hex head capscrews from the cover plate.

Lift cover plate from the separator tank.

Run this procedure

2000 Hourly Compressor Maintenance

Cleaned the return line strainer?

Replaced the fluid filter element?

Sign off on the 2000 hourly compressor maintenance

Run this procedure

2000 Hourly Fluid Filter Replacement

FILTER MAINTENANCE

Replace the fluid filter element under any of the following conditions, or whichever occurs first

FLUID FILTER ELEMENT REPLACEMENT

Use a wrench to remove the filter canister

Remove and dispose of filter element properly

Note! Dispose of fluids in accordance with applicable federal, state and local regulations

Clean gasket seating surface

Apply a light film of fluid to the element seal

Install the element into the filter canister

Run this procedure

Compressor Routine Maintenance

Warning: HIGH-PRESSURE HAZARD! DO NOT remove caps, plugs, and/or other components when compressor is running or pressurized. Stop compressor and relieve all internal pressure before doing so. Failure to comply could result in death or serious injury.

Fluid level in the receiver tank is at the mid-point

Frequent addition of fluid required?

If frequent addition of fluid is required, it indicates the presence of a leak or a condition causing excessive fluid consumption.

Proper indications on the controller display after routine start

All compressor operation indications are normal after the compressor has warmed up

Sign off on the compressor routine maintenance

Run this procedure