Stryker Stryker MedSurg Bed with StayPut Frame 3005 3005

CAUTION: Do not clean, disinfect, service, or perform maintenance while the product is in use.

Always unplug the power cord from the wall outlet when large spills occur near the circuit boards, cables, and motors.

Always wipe down with clean water (or 70% isopropyl alcohol, if using Virex® TB) and dry each product after disinfecting.

Always clean Velcro® after each use. Saturate Velcro with disinfectant and allow disinfectant to evaporate.

Do not use quaternary disinfectants formulated with glycol ethers.

Choose the recommended disinfectant for this product’s surfaces

Followed the manufacturer's dilution recommendations exactly?

Applied the recommended disinfectant solution by spray or pre-soaked wipes?

Hand washed all surfaces of the product with the recommended disinfectant?

CAUTION: Do not clean, disinfect, service, or perform maintenance while the product is in use.

Always unplug the power cord from the wall outlet when large spills occur near the circuit boards, cables, and motors.

Remove the patient from the product, clean up the fluid, and inspect the product. Fluids can cause unpredictable operation and decreased functionality of any electrical product. Do not return the product to service until it is completely dry and you have tested for safe operation.

Always clean Velcro® after each use. Saturate Velcro with disinfectant and allow disinfectant to evaporate. Appropriate disinfectant for nylon Velcro should be determined by the hospital.

Hand wash all surfaces on the product with a mild detergent using spray or pre-soaked wipes.

Follow the cleaning solution manufacturer’s instructions for appropriate contact time and rinsing requirements.

Dry the product thoroughly before you return the product to service.

Avoid over saturation. Do not allow the product to remain wet.

Wipe down the external product surface with a fresh, clean wipe to remove all visible soils

Repeat as necessary until the external product surface is visibly clean

Wipe dry with a cloth or allow the external product surface to air dry before you return the product to service

Wipe down the external product surface with a fresh, clean wipe until wet

Allow the external product surface to remain wet for two minutes at room temperature

Wipe dry with a cloth or allow the external product surface to air dry before you return the product to service

Spray SideKick on a mop, sponge, paper cloth, or cloth towel

Wipe down the external product surface with a fresh, clean mop, sponge, paper cloth, or cloth towel to remove all visible soils

Repeat as necessary until the external product surface is visibly clean

Wipe dry with a cloth or allow the external product surface to air dry before you return the product to service

Spray SideKick on a mop, sponge, paper cloth, or cloth towel

Wipe down the external product surface with a fresh, clean mop, sponge, paper cloth, or cloth towel until wet