Nordson Dispensing Workstation Ultra 2400

EFD syringe barrel filled with assembly fluid attached to the adapter assembly

Set vacuum at 0.0 during initial testing

Replaced the orange tip cap with an EFD precision dispense tip

Syringe barrel slid into the hand grip and snapped in place

Pulled the air pressure regulator knob out until it clicked into the unlocked position

Start with pressure set to 0 psi (0.0 bar)

Attach an EFD syringe barrel filled with your assembly fluid to the adapter assembly as shown

Set the vacuum at 0.0 during initial testing

Replace the orange tip cap with an EFD precision dispense tip

Slide the syringe barrel into the hand grip. Snap in place

Follow steps in “Testing in Steady Mode” to purge your dispensing tip with fluid

Rest the dispense tip on the Dot Standards sheet

EFD syringe barrel filled with assembly fluid attached to the adapter assembly

Set vacuum at 0.0 during initial testing

Orange tip cap replaced with an EFD precision dispense tip

Syringe barrel slid into the hand grip and snapped in place

Dispensing tip purged with fluid