Magnetrol International Level Switch A15-2G3T-HM3

Ensure enclosing tube is tightened and middle set screw is locked to the enclosing tube.

Is the control equipped with a pneumatic switch mechanism?

Loosen set screw(s) at base of switch housing.

Rotate switch housing to desired conduit entry position.

Tighten set screws at base of housing.

Unscrew and remove switch housing cover.

Inspect for excessive wear on actuating lever or misalignment of adjustment screw

Refer to switch mechanism bulletin if adjustment or replacement is necessary

Check for Defective or Maladjusted Switch Mechanisms

Ensure control is not operated with defective or maladjusted switch mechanisms

Check for brittle insulation on electrical wiring

Replace wiring at first sign of brittle insulation

Check that all parts are in place

Is the switch housing cover intact and undamaged?

Are all seals intact and undamaged?

Clean the switch housing cover to remove dust and dirt

Ensure no moisture is present inside the switch housing

Is the switch mechanism operating without interference?

Unpacking and Initial Inspection

Unpack the instrument carefully

Report any concealed damage to carrier within 24 hours

Check the contents of the packing slip

Verify against the purchase order

Record the serial number for future reference

Ensure the instrument is used in Installation Category II, Pollution Degree 2.

Handle displacer spring and stem with care to avoid damage.

Displacer Adjustment and Installation

Adjust displacers on the cable for desired switch actuating levels.

Screw displacer cable fitting to the threaded connection link on the control.

Ensure no obstacles in the tank or vessel interfere with displacer operation.

Determine if a guide pipe or tube is necessary due to liquid turbulence.