Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.

Documents & Manuals

Find all the essential guides in one place.

Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more

Work Order Templates

Pre-built workflows to keep your asset running smoothly.

Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more

Procedures

Integrate maintenance plans directly into your work orders.

Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more

Parts

Access the parts list for your equipment in MaintainX.

Drive Motor
B2 Rollers
Tensioning System
+ 40 more

Kubota Tractor M8540

Create an account to install this asset package.

Maintenance Plans for Kubota Tractor Model M8540

Integrate maintenance plans directly into your work orders in MaintainX.

100 Hourly Air Cleaner Primary Element Cleaning

1. Remove the air cleaner cover and primary element.

2. Clean the primary element:

(1) When dry dust adheres to the element, blow compressed air from the inside, turning the element.

Pressure of compressed air must be under 205 kPa (2.1 kgf/cm , 30 psi).

(2) When carbon or oil adheres to the element, soak the element in detergent for 15 minutes then wash it several times in water, rinse with clean water and dry it naturally.

After element is fully dried, inspect inside of the element with a light and check if it is damaged or not.

3. Replace air cleaner primary element:

Once yearly or after every sixth cleaning, whichever comes first.

NOTE! Check to see if the evacuator valve is blocked with dust.

Run this procedure

100 Hourly Battery Condition Check

DANGER! To avoid the possibility of battery explosion:

Refillable type battery fluid level is between the UPPER and LOWER levels

CAUTION! To avoid personal injury:

Battery cap is not removed while the engine is running

Electrolyte is kept away from eyes, hands and clothes

Open sparks and flames are kept away from the battery at all times

Eye protection and rubber gloves are worn when working around battery

Battery condition indicator

Battery Cable Connections

Run this procedure

100 Hourly Brake Pedal Adjusting

To avoid personal injury:

Stop the engine and chock the wheels before checking brake pedal.

To prevent uneven braking, the specification must be within the recommended limit.

If found out of the specifications, contact your local KUBOTA Dealer for adjusting the brakes.

Checking the brake pedal free travel

Proper brake pedal free travel - 7 to 14 mm (0.3 to 0.6 in.) on the pedal

Keep the free travel in the right and left brake pedals equal.

1. Set the parking brake.

2. Slightly depress the brake pedals and measure free travel at the top of pedal stroke.

Run this procedure

100 Hourly Clutch Pedal Adjusting

Warning: Stop the engine and remove the key before starting the procedure

Measure free travel at the top of pedal stroke

Is the free travel within 40 to 50 mm?

If adjustment is needed, follow the next steps

Loosen the lock nut

Turn the turnbuckle to adjust the rod length within acceptable limits

Retighten the lock nut

Sign off on the clutch pedal adjustment

Run this procedure

100 Hourly Fan Belt Tension Adjusting

CAUTION! To avoid personal injury: Be sure to stop the engine before checking belt tension.

Engine stopped and key removed

Apply moderate thumb pressure to belt between pulleys. Enter the deflection of the belt (in mm)

Is the deflection of the belt within 10 to 12 mm?

If tension is incorrect, were the alternator mounting bolts loosened?

Was a lever placed between the alternator and the engine block to pull the alternator out until the deflection of the belt falls within acceptable limits?

Was the fan belt replaced if it was damaged?

Sign off on the fan belt tension adjustment

Run this procedure