KSB SE & Co. KGaA Chemical Pump CPKN 50-200

Ensure all safety regulations at the installation site are observed.

Perform maintenance work on explosion-proof pump sets outside potentially explosive atmospheres.

Ensure the pump set cannot be started unintentionally and electrical connections are disconnected before work.

Take appropriate measures to protect persons and the environment when draining hazardous fluids.

Secure the pump or pump parts during assembly/dismantling to prevent tipping or falling.

Service the pump set regularly with emphasis on lubricants, shaft seal, and coupling.

Check the lubricant level regularly.

Ensure compliance with safety regulations at the installation site

Perform maintenance outside potentially explosive atmospheres

Ensure pump set cannot be started unintentionally

Disconnect electrical connections before starting work

Take measures to protect against hazardous fluids

Secure pump parts to prevent tipping or falling

Prepare a maintenance schedule focusing on lubricants, shaft seal, and coupling

Ensure suitable temperature monitoring for gland packings is in place

Verify that gland packing is tightened correctly

Avoid contact with unprotected rotating parts

Lightly tighten the nuts of the gland follower by hand

Verify that the gland follower is mounted centred and at a right angle to the shaft using a feeler gauge

Is the gland leaking after the pump has been primed?

Ensure maintenance work is performed outside potentially explosive atmospheres

Verify electrical connections are disconnected

Secure the pump to prevent tipping or falling over

Check the condition of the lubricant

Is the lubricant in good condition?

Describe any issues found with the lubricant

Ensure maintenance work is performed outside potentially explosive atmospheres.

Verify that the pump set cannot be started up unintentionally.

Disconnect electrical connections before starting work on the pump set.

Secure the pump set to prevent tipping or falling over during assembly/dismantling.

Wear safety clothing and a protective mask, if required.

Prepare a maintenance schedule focusing on lubricants, shaft seal, and coupling.

Ensure all maintenance work is performed by authorised, qualified specialist personnel.