Ingersoll Rand Rotary Screw Air Compressor R7.5i-200 TAS

Replace Premium Coolant (Ultra)

Replace Minimum pressure check valve (MPCV)

Condensate Drain Line Inspection

Check Condensate drain lines for any issues

Replace Condensate drain lines if necessary

Isolate the compressor from the system

Press the emergency stop to vent the separator tank and airend

Ensure the main power disconnect switch is locked off and tagged

Remove the outer belt guard from the airend support

Loosen the four motor support plate bolts to allow the plate to pivot

Loosen the nut on the belt tensioning (carriage) bolt

Locate and adjust the jack bolt to raise the assembly

Clean condenser with compressed air, do not damage fins

Is the dryer working properly after maintenance?

Inspect Starter box power drive element (PDM) filter element (if applicable)

Inspect and test pressure relief valve

Inspect Airend/Pressure System/Receiver

Check High Airend Temperature Sensor

Inspect external surfaces of the airend for damage, corrosion, and abrasions

Check Connections and hoses for leaks

Check coolant level in sight glass

Isolate the compressor from the external air system

Press the emergency stop to vent the separator tank and airend

Ensure the main power disconnect is locked off and tagged