Hussmann Low and Medium Temperature Self Contained Island Merchandiser ISMGG-10B

CAUTION! DO NOT FLOOD! Use only enough water necessary to clean surface. Water must not drip down the case! Never use ammonia based cleansers, abrasive cleansers, or scouring pads.

Used non-abrasive cleaning materials and polished with grain of the steel

Used warm water or added a mild detergent to the water and applied with a cloth. Wiped rails dry after wetting.

Did not use cleaners containing salts

Sign off on the cleaning procedure

Product removed and placed in a refrigerated area

Power to the merchandiser turned off

Interior panels from under the nosing heater removed

Interior panel support bracket removed

Existing screws from sheet metal nosing panel removed

Existing anti-sweat heater unplugged and removed

Anti-sweat heater taped as shown in the illustrations

WARNING! Do NOT use HOT water on Cold glass Surfaces. This can cause the glass to shatter and could result in personal injury. Allow glass fronts, to warm before applying hot water.

Use steel wool to smooth out the surface area of the bumper.

Apply vinyl or car wax and polish surface for a smooth glossy finish.

Upload a photo of the bumper after the procedure

Sign off on the procedure completion

• Long life and satisfactory performance of any equipment is dependent upon the care it receives. To ensure long life, proper sanitation and minimum maintenance costs, these merchandisers should be thoroughly cleaned, all debris removed and the interiors washed down, weekly.

• The exterior surfaces must be cleaned with a mild detergent and warm water to protect and maintain their attractive finish. NEVER USE ABRASIVE CLEANSERS OR SCOURING PADS.

• The interior surfaces may be cleaned with most domestic detergents, ammonia based cleaners and sanitizing solutions with no harm to the surface. Self contained models empty into a limited capacity evaporation pan, which will overflow if excess water is used in cleaning.

• Abrasive cleansers and scouring pads, as these will mar the finish.

• Coarse paper towels on coated glass.

• Ammonia-based cleaners on acrylic parts.

Warning: This procedure requires trained personnel with PPE!

Use PRESTOLITE TORCH ONLY. Number 6 tip

Maintain separate set of stainless steel brushes, and USE ONLY ON ALUMINUM

Brush tinned surface UNDER HEAT, thoroughly filling the open pores around leak

Repair leak. Let aluminum melt solder, NOT the torch