Hill-Rom Electric Hospital Bed Advanta

Turn off the air system power at the footboard

Remove the mattress from the bed

Raise the bed to the high position using the hilow function

SHOCK HAZARD: Unplug the bed from its power source. Failure to do so could result in personal injury or equipment damage

Unplug the bed from its power source

Using the T25 Torx® head screwdriver, loosen the screws (A) securing the seat section panel (B) to the bed frame

CAUTION: If your bed is equipped with the Patient Position Monitor, do not set heavy objects directly on the pressure switches. Damage can occur to the pressure switches

Place the seat section panel (B) to one side, not on the pressure switches

Remove the screws (C) securing the air control cover (D) to the bed, and remove the air control cover (D) from the bed

Raise the bed to the high position using the hilow function.

SHOCK HAZARD: Unplug the bed from its power source. Failure to do so could result in personal injury or equipment damage.

Unplug the bed from its power source.

Remove the mattress from the bed (see “Air Sleep Surface Mattress” on page 4-17).

Remove the seat section panel and air control cover from the bed (see “Air Control Cover” on page 4-15).

Disconnect the connectors (A) going to the air control P.C. board (C) (see figure 4-9 on page 4-26).

Using the small flat head screwdriver, remove the two screw locks (D) on the connector.

CAUTION: To prevent component damage, ensure that your hands are clean and only handle the P.C. boards by their edges.

CAUTION: When handling electronic components, wear an antistatic strap. Failure to do so, could result in component damage.

Raise the bed to the high position using the hilow function.

SHOCK HAZARD: Unplug the bed from its power source. Failure to do so could result in personal injury or equipment damage.

Unplug the bed from its power source.

Remove the mattress from the bed (see “Air Sleep Surface Mattress” on page 4-17).

Remove the seat section panel and air control cover from the bed (see “Air Control Cover” on page 4-15).

Using the small flat head screwdriver, remove the two screw locks (D) on the connector (A) (see figure 4-12 on page 4-35).

Disconnect the connector (A) going from the air control P.C. board.

Using the T25 Torx®1 head screwdriver, remove the screw (B) securing the air system weld assembly to the frame of the bed.

Carefully lift up the air system weld assembly (C) and place it on the thigh section of the sleep surface.

CAUTION: Attach the large air hose to the air sleep surface compressor with a cable tie. If the hose becomes unattached during operation, equipment damage could occur.

Compressor installed in the reverse order of removal

Large air hose attached to the air sleep surface compressor with a cable tie

Function checks performed as per page 2-6

Sign off on the compressor replacement

SHOCK HAZARD: Unplug the bed from its power source. Failure to do so could result in personal injury or equipment damage.

Unplug the bed from its power source.

Lift the foot section (B) to access the air hose coupling (D) and cable connector (C) (see figure 4-6 on page 4-17).

Depress the air hose coupling (D) to disconnect the mattress air hose from the bed.

Disconnect the cable connector (C).

Disconnect the plastic buckle (E) holding the mattress in place.

Remove the mattress (A) from the bed.

Sign off on the mattress removal