Hill-Rom Birthing Bed P3700

Set the brake/steer pedal to the brake position

Ensure that the bed is out of the Trend-Like position

Using the hilow function, raise the bed to the high position

Using the head function, raise the head section to the high position

SHOCK HAZARD: Unplug the unit from its power source. Failure to do so could result in personal injury or equipment damage

Unplug the bed from its power source

Remove the bottom motor cover (refer to procedure 4.2)

Identify and disconnect all wiring connectors (A) from the air system control P.C. board (B) (see figure 4-27 on page 4-57)

Using the phillips head screwdriver, remove the screw (C) that secures the air system control board (B) to the air system bracket (D)

Installation of the replacement air system control P.C. board

Are the wiring connectors firmly connected to the air system control P.C. board receptacles?

Did the Affinity® Three Birthing Bed pass the function checks?

Remove the air system assembly (refer to procedure 4.20)

Disconnect the air hoses from the manifold assembly (A) (see figure 4-26 on page 4-55)

Identify and disconnect the wiring connectors (B) from the manifold assembly (A)

Using the phillips head screwdriver, remove the two screws (C) that secure the manifold assembly (A) to the mounting plate (D)

SHOCK HAZARD: The voltage in the electrical system presents an electrical shock hazard. Perform standard electrical service procedures before attempting service within the P.C. board enclosure. Adhere to all electrical safety precautions when servicing the bed’s electrical system. Failure to do so could result in personal injury or equipment damage.

Set the brake/steer pedal to the brake position.

Ensure that the bed is out of the Trend-Like position.

Using the head function, raise the head section to the high position.

Using the hilow function, raise the bed to the high position.

Using the foot function, lower the foot section to the low position.

Remove the foot section from the bed. Refer to “Foot Section (Lift Off)” on page 4-42 or “Foot Section (Slide Off)” on page 4-44.

SHOCK HAZARD: Unplug the unit from its power source. Failure to do so could result in personal injury or equipment damage.

Unplug the bed from its power source, and engage the lockout control.

Installation of the replacement auxiliary outlet assembly

Is the wiring connector (A) firmly connected to the auxiliary transformer assembly (B)?

Did the Affinity® Three Birthing Bed pass the function checks?

Sign off on the auxiliary outlet assembly replacement