Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.

Documents & Manuals

Find all the essential guides in one place.

Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more

Work Order Templates

Pre-built workflows to keep your asset running smoothly.

Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more

Procedures

Integrate maintenance plans directly into your work orders.

Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more

Parts

Access the parts list for your equipment in MaintainX.

Drive Motor
B2 Rollers
Tensioning System
+ 40 more

Epson Multimedia Projector EX5260

Create an account to install this asset package.

Maintenance Plans for Epson Multimedia Projector Model EX5260

Integrate maintenance plans directly into your work orders in MaintainX.

Projector Case Cleaning

Warning: Before cleaning any part of the projector, turn it off and unplug the power cord.

Warning: Never open any cover on the projector, except as specifically explained in this manual. Dangerous electrical voltages in the projector can injure you severely.

Warning: Do not try to service this product yourself, except as specifically explained in this manual. Refer all other servicing to qualified servicers.

Cleaning the Projector Case

Before cleaning the projector case, turn off the projector and unplug the power cord.

To remove dust or dirt, use a soft, dry, lint-free cloth.

To remove stubborn dirt, use a soft cloth moistened with water and mild soap. Do not spray liquid directly on the projector.

Caution: Do not use wax, alcohol, benzine, paint thinner, or other chemicals to clean the projector case. These can damage the case.

Do not use canned air, or the gases may leave a flammable residue.

Run this procedure

Air Filter and Vents Cleaning

Warning: Ensure the projector is turned off and unplugged before starting the cleaning process.

Is the projector turned off and unplugged?

Upload a photo of the dusty air filter or vents

Was the dust gently removed using a small vacuum or a very soft brush?

Note: You can remove the air filter so you can clean both sides of it. Do not rinse the air filter in water, or use any detergent or solvent to clean it.

Caution: Do not use canned air. The gases may leave a flammable residue or push dust and debris into the projector's optics or other sensitive areas.

Was the air filter cleaned without using canned air, water, detergent or solvent?

Is the dust difficult to remove or the air filter damaged?

If dust is difficult to remove or the air filter is damaged, replace the air filter.

Run this procedure

Remote Control Batteries Replacement

Caution: Use only the type of batteries specified in this manual. Do not install batteries of different types, or mix new and old batteries.

Remove the battery cover as shown.

Remove the old batteries.

Warning: If the battery fluid has leaked, wipe it away with a soft cloth and avoid getting the fluid on your hands. If it gets on your hands, wash them immediately to avoid injury.

Insert the batteries with the + and– ends facing as shown.

Replace the battery cover and press it down until it clicks into place.

Warning: Dispose of used batteries according to local regulations. Do not expose batteries to heat or flame. Keep batteries out of the reach of children; they are choking hazards and are very dangerous if swallowed.

Sign off on the battery replacement procedure

Run this procedure

Air Filter Replacement

Replacing the Air Filter

You need to replace the air filter in the following situations:

• After cleaning the air filter, you see a message telling you to clean or replace it

• The air filter is torn or damaged

You can replace the air filter while the projector is mounted to the ceiling or placed on a table.

1. Turn off the projector and unplug the power cord.

2. Carefully open the air filter cover.

3. Pull the air filter out of the projector.

Note: Air filters contain ABS resin and polyurethane foam. Dispose of used air filters according to local regulations.

Run this procedure

Projector Lens Cleaning

Warning: Before cleaning any part of the projector, turn it off and unplug the power cord.

Warning: Never open any cover on the projector, except as specifically explained in this manual. Dangerous electrical voltages in the projector can injure you severely.

Warning: Do not try to service this product yourself, except as specifically explained in this manual. Refer all other servicing to qualified servicers.

Cleaning the Lens: Clean the projector's lens periodically, or whenever you notice dust or smudges on the surface.

Did you moisten a soft, lint-free cloth with lens cleaner and gently wipe the lens?

Warning: Do not use a lens cleaner that contains flammable gas. The high heat generated by the projector lamp may cause a fire.

Caution: Do not use glass cleaner or any harsh materials to clean the lens and do not subject the lens to any impacts; you may damage it.

Do not use canned air, or the gases may leave a residue. Avoid touching the lens with your bare hands to prevent fingerprints on or damage to the lens surface.

Did you avoid using canned air and touching the lens with your bare hands?

Run this procedure