Conair Thermolator Temperature Control Unit IC-12kW-208V

Inspection of Cooling and Process Lines

Inspect the following for leaks

Were any leaks detected during inspection?

Stop the Thermolator if a leak is detected

Describe the location and nature of the leak

Disconnect and lockout the main power

Shut off the cooling water infeed

Drain the unit using the drain plugs located at the bottom

Power Disconnection and Lockout

Remove the top panel of the Thermolator

Use a 1/4-inch open-end wrench to remove the three bolts holding the cap to the heater tank

Inspect the fluid reservoir for debris or deposits

Is flushing and cleaning of the reservoir necessary?

Remove the top panel of the Thermolator

Locate the reservoir near the top of the unit

Locate the fill port at the top of the reservoir

Monitor the fluid level using the sight glass on the back of the unit

Disconnect and lock out main power to the unit

Press any button to display the first test menu