Climate Master Heat Pump GLH120BFD3ACLSS

Check the shipment against the bill of lading

Inspect the carton or crating of each unit for damage

Ensure carrier makes proper notation of any shortages or damage on all copies of the freight bill

Complete a common carrier inspection report

Wear protective gloves to avoid injury from sharp fin edges

Ensure no damage to aluminum fins during cleaning

Inspect for any remaining debris

Ensure the cabinet is elevated from the floor to prevent water contact

Prepare a mild detergent solution

Apply the mild detergent solution to the cabinet surfaces

Wipe the cabinet with a clean, damp cloth

Ensure no water remains on the cabinet surfaces

Ensure that electrical power to the unit is disconnected

Install the system with the supply hose connected directly to the return riser valve using a single length of flexible hose

System Filling and Air Bleeding

Open all air vents and fill the system with water without overflowing

Bleed all air from the system and pressurize it

Check the system for leaks and repair as appropriate

Use the manual air bleed valve at the top of the reheat coil for ClimaDry-equipped units

Is the system installed in an area with high mineral content (125 P.P.M. or greater)?

Is the piping known to have high dirt or debris content?

Measure the water flow rate through the unit (l/s per kW).

Is the water flow rate above 0.0269 l/s per kW and below 0.0537 l/s per kW?

Is periodic coil cleaning necessary?

Use standard coil cleaning procedures compatible with the heat exchanger material and copper water lines.