Climate Master Heat Pump GLH096BUC3AALSS

Ensure that electrical power to the unit is disconnected

Install the system with the supply hose connected directly to the return riser valve using a single length of flexible hose

System Filling and Air Bleeding

Open all air vents and fill the system with water without overflowing

Bleed all air from the system and pressurize it

Check the system for leaks and repair as appropriate

Use the manual air bleed valve at the top of the reheat coil for ClimaDry-equipped units

Check the shipment against the bill of lading

Inspect the carton or crating of each unit for damage

Ensure carrier makes proper notation of any shortages or damage on all copies of the freight bill

Complete a common carrier inspection report

Gather necessary cleaning tools

Inspect the air coil for dirt accumulation

Brush or vacuum clean the air coil if dirty

Handle with care to avoid damaging aluminum fins

Ensure the cabinet is elevated from the floor

Prepare a mild detergent solution

Apply the mild detergent solution to the cabinet

Ensure water does not stay in contact with the cabinet for long periods

Check for any signs of corrosion on the cabinet sheet metal

Dry the cabinet thoroughly to prevent corrosion

Is the system installed in an area with high mineral content (125 P.P.M. or greater)?

Is the piping known to have high dirt or debris content?

Measure the water flow rate through the unit (l/s per kW).

Is the water flow rate at least 0.0269 l/s per kW?

Is the water flow rate below 0.0537 l/s per kW?

Is periodic coil cleaning necessary?