Climate Master Heat Pump GLH240BUC3AALSS

Wear protective gloves to avoid injury from sharp fin edges

Ensure no damage to aluminum fins during cleaning

Inspect for any visible damage to the fins

Ensure that electrical power to the unit is disconnected

System Installation and Initial Setup

Install the system with the supply hose connected directly to the return riser valve using a single length of flexible hose

Open all air vents and fill the system with water

Air Bleeding and Strainer Verification

Use manual air bleed valve to bleed air from the reheat coil for ClimaDry-equipped units

Verify that all strainers are in place with a #20 stainless steel wire mesh

Start the pumps and check each vent to ensure all air is bled from the system

Ensure the cabinet is elevated from the floor

Prepare a mild detergent solution

Apply the mild detergent solution to the cabinet

Wipe the cabinet thoroughly to remove detergent

Ensure no water remains in contact with the cabinet

Verify shipment against the bill of lading

Inspect carton or crating of each unit for damage

Ensure carrier makes proper notation of any shortages or damage on all copies of the freight bill

Complete a common carrier inspection report

Was any concealed damage discovered during unloading?

Is the system installed in an area with high mineral content (125 P.P.M. or greater)?

Is the piping known to have high dirt or debris content?

Measure the water flow rate through the unit (l/s per kW).

Is the flow rate within the recommended range of 0.0269 to 0.0537 l/s per kW?

Is periodic coil cleaning necessary?

Perform standard coil cleaning procedures compatible with heat exchanger material and copper water lines.