Climate Master Heat Pump GLH300BUC3AALSS

Check the shipment against the bill of lading

Inspect the carton or crating of each unit for damage

Assure the carrier makes proper notation of any shortages or damage on all copies of the freight bill

Complete a common carrier inspection report for any damage or shortages

Was any concealed damage discovered during unloading?

Record the time of concealed damage discovery

Wear protective gloves to avoid injury from sharp fin edges

Inspect the air coil for dirt and debris

Select the cleaning method used

Clean the air coil without damaging the aluminum fins

Check for any visible damage to the aluminum fins

Ensure the cabinet is elevated from the floor to prevent water contact

Prepare a mild detergent solution

Apply the mild detergent solution to the cabinet surfaces

Wipe the cabinet with a clean, damp cloth

Ensure no water remains on the cabinet surfaces

Is the system installed in an area with high mineral content (125 P.P.M. or greater)?

Is the piping known to have high dirt or debris content?

Measure the water flow rate through the unit (l/s per kW)

Is the flow rate within the recommended range (0.0269 to 0.0537 l/s per kW)?

Is periodic coil cleaning necessary?

Use standard coil cleaning procedures compatible with heat exchanger material and copper water lines

Ensure that electrical power to the unit is disconnected

Install the system with the supply hose connected directly to the return riser valve using a single length of flexible hose

System Filling and Air Bleeding

Open all air vents and fill the system with water without overflowing

Bleed all air from the system and pressurize it

Check the system for leaks and repair as appropriate

Use the manual air bleed valve at the top of the reheat coil for ClimaDry-equipped units