Climate Master Heat Pump GLV160BUC3AALSS

Ensure the cabinet is elevated from the floor

Verify that cleaning materials are ready

Use a mild detergent for cleaning

Ensure no water remains in contact with the cabinet

Gather necessary cleaning tools

Inspect the air coil for dirt accumulation

Brush or vacuum clean the air coil

Handle with care to avoid injury

Is the system installed in an area with high mineral content (125 P.P.M. or greater)?

Is the piping known to have high dirt or debris content?

Measure the water flow rate through the unit (l/s per kW)

Is the flow rate within the recommended range (0.0269 to 0.0537 l/s per kW)?

Is periodic coil cleaning necessary?

Use standard coil cleaning procedures compatible with heat exchanger material and copper water lines.

Check shipment against the bill of lading

Inspect carton or crating of each unit for damage

Ensure carrier makes proper notation of any shortages or damage on all copies of the freight bill

Complete a common carrier inspection report

Ensure that electrical power to the unit is disconnected

System Installation and Initial Setup

Install the system with the supply hose connected directly to the return riser valve using a single length of flexible hose

Open all air vents and fill the system with water without overflowing

Bleed all air from the system and pressurize

Check the system for leaks and repair as appropriate

Use the manual air bleed valve at the top of the reheat coil for ClimaDry-equipped units