Climate Master Heat Pump GLH080BUC3AALSS

Is the system installed in an area with high mineral content (125 P.P.M. or greater)?

Is the piping known to have high dirt or debris content?

Measure the water flow rate through the unit (l/s per kW)

Is the flow rate within the recommended range (0.0269 to 0.0537 l/s per kW)?

Is periodic coil cleaning necessary?

Use standard coil cleaning procedures compatible with heat exchanger material and copper water lines.

Ensure the cabinet is elevated from the floor

Prepare a mild detergent solution

Apply the mild detergent solution to the cabinet

Ensure no water remains in contact with the cabinet for extended periods

Check for any signs of corrosion on the cabinet sheet metal

Dry the cabinet thoroughly to prevent corrosion

Gather necessary cleaning tools

Inspect the air coil for dirt accumulation

Brush or vacuum clean the air coil if dirty

Handle with care to avoid damaging aluminum fins

Ensure that electrical power to the unit is disconnected

System Installation and Initial Setup

Install the system with the supply hose connected directly to the return riser valve using a single length of flexible hose

Open all air vents and fill the system with water without overflowing

Bleed all air from the system and pressurize

Check the system for leaks and repair as appropriate

Use the manual air bleed valve at the top of the reheat coil for ClimaDry-equipped units

Verify shipment against bill of lading

Inspect carton or crating of each unit for damage

Damage Inspection and Reporting

Inspect each unit for visible damage

Assure carrier makes proper notation of any shortages or damage on all copies of the freight bill

Complete a common carrier inspection report for any damage

Was any concealed damage discovered during unloading?