Climate Master Heat Pump GLV096BUC3AALSS

Wear protective gloves to avoid injury from sharp fin edges

Ensure no damage to aluminum fins during cleaning

Inspect for any visible damage to the fins

Check the system installation area

Measure the mineral content in the water (P.P.M.)

Is the mineral content 125 P.P.M. or greater?

Is the piping known to have high dirt or debris content?

Is periodic coil cleaning necessary?

Use standard coil cleaning procedures compatible with heat exchanger material and copper water lines

Verify shipment against the bill of lading

Inspect carton or crating of each unit for damage

Ensure carrier makes proper notation of any shortages or damage on all copies of the freight bill

Complete a common carrier inspection report

Was any concealed damage discovered during unloading?

Ensure the cabinet is elevated from the floor

Is the cabinet free from any items inside?

Use a mild detergent for cleaning

Ensure no water remains in contact with the cabinet for long periods

Describe any issues noticed during cleaning

Ensure that electrical power to the unit is disconnected.

Install the system with the supply hose connected directly to the return riser valve using a single length of flexible hose.

System Filling and Air Bleeding

Open all air vents and fill the system with water without allowing overflow.

Bleed all air from the system and pressurize it.

Check the system for leaks and repair as appropriate.

Use the manual air bleed valve at the top of the reheat coil for ClimaDry®-equipped units.