Clarke Fire Pump Engine JU4H-UFH2

IMPORTANT: Set main pump controller to “OFF” while servicing engine. Before turning the main pump controller to the OFF" position

Warning: An experienced operator should be present during the weekly test.

NOTE: This engine is designed to operate at rated load conditions. For testing purposes the engine can be run at lower load (lower flow) conditions.

Running times in any one period should not exceed 30 minutes maximum.

The operator has free access to stop the engine in an emergency.

The plant room ventilation ducts are open and the engine has good access for air.

All the guards are in position and, if not, for whatever reason, any rotating parts will be free and clear without restriction.

Battery covers are in place and there is nothing on top of or touching the engine, which is not part of the original supply specification.

Heat Exchanger Cooling: The water supply for coolant is available again without restriction.

Radiator Cooling: The air supply for cooling is available again without restriction.

Warning: This maintenance check requires trained personnel with PPE!

Enter the current fuel tank level

Is the fuel tank level above 67%?

If fuel tank level is less than 67%, refill the tank to its full capacity

Open drain at the bottom of the fuel tank to drain off any possible water and/or sediment

Is the fuel tank filled after each test run?

Sign off on the fuel tank maintenance

IMPORTANT: Set main pump controller to “OFF” while servicing engine.

Before turning the main pump controller to the 'OFF' position, check with the maintenance and security supervisors to verify that all the departments concerned will be alerted of the temporary interruption of their fire protection equipment for normal maintenance or testing.

Also, alert the local fire department in the event that the main pump controller is connected by silent alarm to headquarters.

When servicing is complete, return main pump controller selector to 'Automatic' position and the mode selector on the engine to 'Automatic' position.

Advise the appropriate personnel the engine has been returned to the 'Automatic'.

IMPORTANT: Set main pump controller to “OFF” while servicing engine.

Before turning the main pump controller to the 'OFF' position, check with the maintenance and security supervisors to verify that all the departments concerned will be alerted of the temporary interruption of their fire protection equipment for normal maintenance or testing.

Also, alert the local fire department in the event that the main pump controller is connected by silent alarm to headquarters.

When servicing is complete, return main pump controller selector to 'Automatic' position and the mode selector on the engine to 'Automatic' position.

Advise the appropriate personnel the engine has been returned to the 'Automatic'.

Sign off on the engine parts replacement