BINDER Incubator BD-S-UL 56

Ensure compliance with applicable regulations (e.g., DGUV guidelines 213-850 for Germany).

Verify the chamber type and corresponding safety controller class (2 or 3.1).

Safety Controller Function Check

Is the safety controller functioning properly?

Check the safety controller setting for the following chamber types

Set the safety controller set-point 2°C to 5°C above the desired temperature set-point.

Was an alarm message visually reported during the check?

Disconnect the chamber from the power supply

Thoroughly remove any residues of the charging material

Wipe surfaces with a moistened towel

Use appropriate cleaning agents for surfaces

Avoid using acidic or chlorine cleaning detergents

Avoid using neutral cleaning agent on zinc coated surfaces

Disconnect the power plug before starting maintenance work

Ensure the chamber does not become wet during maintenance

Verify that maintenance is conducted by licensed electricians or authorized experts

Legal and Warranty Considerations

Is the maintenance work performed by authorized personnel?

Are legal requirements regarding qualifications, testing, and documentation met?

Is there a maintenance agreement with BINDER Service?

Disconnect the chamber from the power supply by pulling the power plug.

Ensure no decontamination agents that may react with device components are used.

Select the decontamination method based on contamination type and material.

Use adequate personal safety controls during decontamination.

Wear sealed protective goggles to protect eyes from chemical burns.