BINDER Chamber ED115-230V

Disconnect the chamber before cleaning. Disconnect the power plug.

Wear protective gloves and goggles.

Avoid skin contact with cleaning agents.

Ensure no ingestion of cleaning agents. Keep away from food and beverages.

Select cleaning agents for surfaces

Wipe the surfaces with a moistened towel.

Thoroughly remove any residues of the charging material.

Ensure the chamber is disconnected from the power supply

Verify that the chamber is not wet

Confirm the rear panel of the chamber is not removed

Ensure maintenance is conducted by a licensed electrician or authorized expert

Verify the door gasket is cold before replacement

Disconnect the chamber from the power supply by pulling the power plug.

Ensure no decontamination agents that may react with device components are used.

Contact BINDER service if unsure about the suitability of cleaning products.

Select the decontamination procedure based on contamination type

Ensure all inflammable goods are removed before hot air sterilization.