Torit Dust Collector 36CYC

Check all electrical connections for tightness and contact

Check for and remove all loose items in or near the inlet and outlet of the unit

Check that all remote controls are wired into the control system and all service switches are in the OFF position

Check that all optional accessories are installed properly and secured

Check that hopper discharge is open and the storage container is sealed, if equipped

Turn the fan motor ON then OFF to check for proper rotation by referencing the rotation arrow located on the motor’s mounting plate

To reverse rotation, single-phase power supply

To reverse rotation, three-phase power supply

Hopper discharge gates are open and doors, drum covers, and gaskets are firmly in place

Overall performance of the collector is satisfactory

Dust disposal is monitored and dust drawers or drums are emptied when 2/3 full

Collected material is kept a minimum of 10-inches from the end of the cone on hopper models

Fan is turned OFF and filter bags are manually shaken at the end of each shift

Adequate air volume is restored by shaking

Contact information of Donaldson Aftermarket Sales Representative for ordering replacement bags

Filter bags are replaced every two years under normal operating conditions

Unit’s model and serial number for ordering replacement bags