Torit Dust Collector 24CYC

Hopper discharge gates are open and doors, drum covers, and gaskets are firmly in place

Monitor overall performance of the collector

Monitor dust disposal. Empty dust drawers or drums when 2/3 full

Keep collected material a minimum of 10-inches from the end of the cone on hopper models

Turn fan OFF and manually shake filter bags at the end of each shift

If adequate air volume cannot be restored by shaking, contact your Donaldson Aftermarket Sales Representative to order replacement bags

Date of filter bags replacement

Follow the motor manufacturer’s maintenance instructions

NOTICE: Do not run the motor for extended time periods unless all ductwork is in place

1. Check all electrical connections for tightness and contact.

2. Check for and remove all loose items in or near the inlet and outlet of the unit.

3. Check that all remote controls are wired into the control system and all service switches are in the OFF position.

4. Check that all optional accessories are installed properly and secured.

5. Check that hopper discharge is open and the storage container is sealed, if equipped.

7. Turn the fan motor ON then OFF to check for proper rotation by referencing the rotation arrow located on the motor’s mounting plate.

- To reverse rotation, single-phase power supply: Follow manufacturer’s instructions on the motor’s nameplate.

- To reverse rotation, three-phase power supply: Turn electrical power OFF at source and switch any two leads on the output-side of the blower-motor starter.