Stryker Performance-Load Cot Fastener System 6392

Warning: Service only by qualified personnel

Remove product from service before you perform the preventive maintenance inspection

Upload a photo of the cleaned area

Sign off on the maintenance activity

Warning: Service only by qualified personnel

Remove product from service before you perform the preventive maintenance inspection

Established and followed a maintenance schedule

Kept records of the maintenance activity

Need to perform preventive maintenance checks more often based on your level of product usage?

Replaced any worn parts, if necessary

Warning: Service only by qualified personnel

Remove product from service before performing the preventive maintenance inspection

Check loose fasteners – Replace if loose

Record of the maintenance activity

Wipe external surfaces with a fresh, clean wipe to remove all visible soils

Number of wipes used for cleaning

Wipe external surfaces with a fresh, clean wipe until wet

Enter the time in minutes the external surface remained wet

Allow the product to dry before you return it to service

Sign off on the cleaning and disinfecting procedure

Tools required: T27 Torx driver, 15/16'' hex wrench, 3/8'' Allen wrench

Remove and save the four socket head cap screws that secure the foot end cover assembly to the transfer using a T27 Torx driver

Remove and save the two button head cap screws that secure the foot end cover assembly to the foot end nose assembly using a T27 Torx driver

Remove the foot end cover assembly by sliding it toward the head end of the vehicle patient compartment

Reinstall the foot end cover assembly by reversing steps 1-3

Loosen the locknut that secures the pin to the head end forging assembly using a 15/16'' hex wrench

Adjust the pin so there is maximum clearance between the foot end cover assembly during loading and unloading using a 3/8'' Allen wrench

NOTE! The pin must lock into the head end of the fastener while loaded

Tighten the locknut that secures the pin to the head end forging assembly using a 15/16'' hex wrench