Skyjack Skyjack Telehandler SJ1256 THS SJ1256 THS

Servicing windows found on the sides of the boom

Covers removed from the servicing windows

E-chain and hoses examined for damage or wear

Upload a photo of the examined e-chain and hoses

WARNING! The fuel pump high-pressure fuel lines and fuel rail contain very high pressure fuel. Never loosen any fittings while the engine is running. Personal injury and property damage can result

Is the telehandler on a firm level surface?

Is the parking brake applied and the engine shut down with the key removed from the ignition switch?

Is the engine compartment cover unlatched and lifted up?

Is the area around the fuel filter and fuel/water separator clean?

Is a container placed under the filter and separator to collect any escaping fuel when removing them?

Is the water level sensor harness disconnected from the fuel/water separator?

Is the drain plug assembly unscrewed from the bottom of the water separator?

Are the used fuel filter and separator unscrewed and discarded along with any captured spilled fuel?

Each axle has two integral pivot assemblies which attach the axle to the frame. Each of the four pivot assemblies requires independent lubrication.

Axle Pivot Bearings. There are remote grease fittings for pivot bearing lubrication. The front axle grease fittings are located on the right front frame rail next to the frame level cylinder.

The rear axle remote grease fittings are located beside the right boom lift cylinder.

Wipe dirt and grease from each remote grease fitting.

Apply 4 shots of grease to each fitting.

Axle King Pins. Each axle has two king pins. Each king pin has an upper and a lower grease fitting (total of 4 king pins on each axle).

Apply 4 shots of grease to each fitting.

Sign off on the axle pivot bearings and king pins greasing.

Warning: The telehandler must be on level ground and all cylinders retracted when checking oil level.

Is the telehandler on level ground?

Refer to oil sight gauge at rear of tank to check that the hydraulic fluid is between MAX and MIN.

Is the hydraulic fluid between MAX and MIN?

If not, add clean hydraulic oil through the tank filler as required.

Sign off on the hydraulic oil level check

Telehandler parked on a firm level surface

Transmission lever moved to neutral and park brake engaged

Boom fully extended to gain access to front bottom slide pads

Engine shut down and dismounted from cab

Grease smeared along the path of front bottom slide pads

Boom fully retracted then fully extended a few times to ensure the path of slide pads is covered with grease for maximum protection

Boom fully retracted, boom rear cover door removed to gain access to top rear slide pads

Grease smeared along the path of rear top slide pads

Engine shut down and key removed