Rite-Hite High Speed Door Fastrax LD

Controls/Wiring: Clean and check all connections with disconnect off. Make sure all wires are free from moving parts.

Door Assembly: Perform visual inspection for damage. Tighten all hardware. Replace any worn labels. Use air hose to remove dust and debris.

Door Operation: Operate door and make sure all operations are functioning properly

Drive Tube: Verify drive tube gear is centered over track groove. Make sure bearing set screws and mounting bolts are tight.

Gearbox: Check gearbox fluid level; fill with Mobil - SHC 624 or Phillips 66 - Syncon 32

if low Check lock collar set screws.

Encoder/Chain/Sprockets: Verify encoder chain and sprocket set screws are tight. Verify lock collar on encoder is tight. Check open and close positions adjust as required.

FSTXLD/FSTXFRLD: Verify torque arm bolts are tight.

Lintel Seal (not on FR): Verify lintel seal is sealing wall properly.

Warning: Only Rite‑Hite authorized service technicians should change the programming.

NOTE: Advise pedestrians to use man doors if present and not to lean into the door way.

Open the control box and verify the state of the green Input LEDs on the i‑COMM 3

Pillow block bearing set screws tightened to 66 to 80in/lb [7.5Nm]

Wires are connected for the photoeyes

All loose wires are secured away from moving parts

Press the “OPEN” button, the door should open and close automatically after a short delay

Observe the door opening to make sure that it fully opens

Observe the closing action to make sure that the door operates smoothly, and fully closes without excessive curtain ripple

Curtain Fans (Optional): Verify that curtain fans are powered and working. Make sure that the fans are positioned properly and are removing condensation from the curtain.

Auto Re‑Feed: Verify auto re‑feed is operational.

Curtain: Inspect for wear or damage; patch immediately to prevent condensation or frost buildup. Clean with warm soapy water. Check drive spheres; if missing or damaged, replace. Check top roller.

Perimeter Seal (FR): Free of tears and providing an adequate seal against curtain and the wall. If torn, patch immediately to prevent condensation build‑up.

Vision (not on FR): Inspect vision for tears or separation. Clean with warm soapy water.

Radial and Track Lubrication: Lubrication of radials and tracks may be required more than every 6 months, based on usage and environmental conditions.

Lubrication of the radials and tracks is the sole responsibility of the end user. If door is mounted in a dirty environment, it may be required to remove the existing grease prior to adding new.;

Warning: This procedure requires trained personnel with PPE!

Adhesive applied to curtain edge drive sphere stud

Adhesive applied to stud before tightening

Adhesive oozed out both sides after stud is tightened

Stud tightened prior to adhesive starting to dry

Sign off on the drive sphere replacement

Loosen lock collar (C) using 2mm Allen wrench and slide encoder off of shaft (A)

Install new encoder, tighten lock collar (14in-lb. [1.5Nm]), line up notch and screw connector

Proceed to 'Limit (Encoder) Set-up' on page 68

Sign off on the encoder replacement