Rite-Hite High Speed Door Fastrax FR LD

All connections clean and checked with disconnect off

All wires are free from moving parts

Visual inspection for damage performed

Dust and debris removed using air hose

Warning: Only Rite‑Hite authorized service technicians should change the programming.

NOTE: Advise pedestrians to use man doors if present and not to lean into the door way.

Open the control box and look at the row of (X) green Input LEDs on the i‑COMM 3 and the label to verify proper state.

Check and remedy: Pillow block bearing set screws tightened to 66 to 80in/lb [7.5Nm].

Check and remedy: Wires are connected for the photoeyes.

Check and remedy: All loose wires are secured away from moving parts.

With the power on, press the “OPEN” button, the door should open and close automatically after a short delay.

Operate and observe the door opening to make sure that it fully opens. Observe the closing action to make sure that the door operates smoothly, and fully closes without excessive curtain ripple. Black edging of curtain should not impact the floor.

While the door is closing, block the reversing photoeyes. The door should reverse direction, move to the open position, and continue to operate.

Curtain fans are powered and working

Curtain fans are positioned properly and are removing condensation from the curtain

Curtain inspected for wear or damage

Upload a photo of the patched curtain

Drive spheres checked and replaced if missing or damaged

Perimeter Seal (FR) is free of tears and providing an adequate seal against curtain and the wall

Upload a photo of the patched Perimeter Seal (FR)

Warning: This procedure requires trained personnel with PPE!

Type of adhesive used for the procedure

Adhesive applied to curtain edge drive sphere stud?

Adhesive applied to stud before tightening?

Adhesive oozed out both sides after stud is tightened?

Enter the time taken for adhesive to dry

Sign off on the drive sphere replacement

Loosen lock collar (C) using 2mm Allen wrench and slide encoder off of shaft (A)

Install new encoder and tighten lock collar (14in-lb. [1.5Nm])

Line up notch and screw connector

Proceed to 'Limit (Encoder) Set-up' on page 68

Sign off on the encoder replacement