Pentair Plunger Pump 2230A-P

Ensure the following tools are available

Replace the plunger seals if there is water leakage from the weephole

Use a 3/16" Allen wrench to remove the cylinder head bolts

Remove the head from the crankcase assembly

Rotate the shaft and remove the cup retainers from the plungers

Remove the cup retainer and the cup from the cylinder head

Check the oil level using the dipstick

Drain the old oil from the pump

Enter the amount of oil added (in fl. oz.)

Verify the oil level is correct after refilling

Oil Seal Replacement for 2200B-P and 2300B-P Series

Ensure the following tools are available

Drain the oil from the crankcase using a 9/16" hex wrench

Remove the plunger retaining nuts with a 9/16" hex wrench

Remove the plungers and slinger rings

Ensure the pump is turned off before starting lubrication.

Verify the following items are available

Check the oil level using the dipstick

Is the oil level within the recommended range?

Record the crankcase capacity for PowerLine Plus 2200B-P pumps

Change the oil if it has been 500 hours of operation or 3 months since the last change.

Remove the pump head from the crankcase as described in the packing replacement section.

Remove the plunger retaining nut.

Carefully slide the plunger off of the lower plunger.

Remove the o-ring from the lower plunger.

Remove the plunger retaining nut and slinger ring.

Inspect the plungers for cracking or damage.