John Deere Sprayer 4940

Pressure relieved from de-aeration tank cap

Cap removed from de-aeration tank

Enter the coolant solution test results

Coolant tested using TY26605 COOL-GARD™II 3-way test strips

TY26603 COOL-GARD II Coolant Extender added as indicated by the color matrix on reader card in test strip pack

Small amount of coolant drained from system before extender is added if tank is too full

Activate tread adjust until axle tubes are fully extended

Remove cap screws (A) and coat with anti-seize compound

Install and tighten cap screws (A) to specification

Repeat tightening until all three cap screws torques are maintained

Loosen cap screws (A) 1/6 of a turn

Tighten jam nuts (B) to specification

Adjust the tread adjust sensors

Lubricate steering cylinder tie rod ends

Solution tank straps tightness checked

Solution tank straps tightened if loose

Boom lift arm pivots lubricated

Drain fuel filter water separator

1. Close flowmeter shut-off valve (A).

2. Remove plug (A) and drain solution into bucket or suitable container.

3. Loosen and remove ring nut (B).

4. Remove cover (C) from end of strainer body (D) and drain solution into bucket or suitable container.

Replace air compressor air dryer cartridge

Relieve air system pressure by opening valve (A)

Remove cap screws (A), nuts, and clamps that secure alternator harness

Remove cap screws (B) and tilt air dryer and mounting bracket assembly (C) until dryer cartridge can be accessed

Using a strap wrench, turn the desiccant cartridge (A) counterclockwise, remove and discard

Remove and discard O-ring (B) from adapter plate stud

Clean top surface of adapter plate (D) and threaded stud

Apply a light coat of grease (supplied with new cartridge) to O-ring. Install O-ring on adapter plate