John Deere Tractor 6105D

Change transmission-hydraulic oil and filter

1. Move rockshaft lever full forward to lower hitch all the way down.

3. Replace transmission-hydraulic oil filter. (See procedure in this section.)

5. Remove cap (B) and fill system with oil as specified in Fuels, Lubricants and Coolant section.

6. Check oil level at sight glass (A) after filling.

8. Start engine and operate for five minutes.

Transmission-hydraulic oil filter replaced?

MFWD axle and wheel hub oil changed?

Sign off on the tractor maintenance

2. Check level in coolant reservoir BEFORE starting tractor.

3. If engine is COOL and level is below MIN COLD mark, remove cap and add coolant to reservoir to bring level between MIN and MAX COLD mark.

1. Disconnect wiring harness (A).

2. Connect a small hoses to end of drains (B).

Replace engine air intake filters

2. Loosen latch (A) and remove cover (B).

3. Pull out primary filter element (A). Do not use excessive force. If filter does not pull out with ease, move side-to- side to remove safely.

4. Pull out secondary element (B) using handle on filter's frame.

5. Install new secondary element. Push in all the way.

6. Install new primary element with rubber seal first (arrows on label pointing into filter housing). Push in all the way.

7. Close cover and raise catch.

Drain, flush and refill engine cooling system

Drain, flush and refill engine cooling system (5000 Hourly / 5 Yearly Maintenance)

Test or replace thermostat (5000 Hourly / 5 Yearly Maintenance)

Sign off on the tractor maintenance