John Deere John Deere Tractor 5115M 5115M

Park machine, shut off engine, and remove key.

Remove and retain cap screws (A), wire clips (B), connector clip (C), and fan shield (D).

Remove and retain cap screws (A), lock nut (B), and fan shield (C).

Inspect hose clamps (A) on the bottom of the coolant tank. Tighten any loose hose clamps.

Inspect hose clamps (A). Tighten any loose hose clamps.

Inspect hose clamps (A). Tighten any loose hose clamps.

Inspect hose clamps (A). Tighten any loose hose clamps.

Reinstall shields and lower hood before operating machine.

Machine parked on level ground and engine shut off

Engine oil fill cap/dipstick (A) removed, wiped off, then fully reinserted

Engine oil level checked. Oil level is between two marks on dipstick

If level is low, oil added through engine oil fill hole until even with the top mark on dipstick. Not overfilled

Engine oil fill cap/dipstick (A) reinstalled before operating engine

Clean Air Filter Dust Unloading Valve

Change Open Crankcase Ventilation Filter

Remove and retain cap screw (A), spring (B), and lock nut (C)

Loosen hose clamp (C) and remove hose (D) on top of the open crankcase vent filter housing

Loosen hose clamp (G) and remove hose (H) on bottom of the open crankcase vent filter housing

Unscrew open crankcase vent filter housing top and remove filter

Inspect open crankcase vent filter housing. Clean if necessary

Install new filter and reinstall filter housing top

Reinstall open crankcase vent filter housing

Change Transmission/Hydraulic Oil and Filter

Check Hitch and Drawbar for excessive wear

Lubricate Draft Sensing Shaft Seal