Hobart Dishwasher AM15VL

Clean off the dish tables into the dishwasher

Drain the machine by lifting up the drain lever (Does not apply to AM15SVL or AM15SVLT models)

Thoroughly cleanse and flush the dishwasher interior. Remove remaining soil with a soft cloth or brush and mild cleanser. Rinse again

Remove and empty the strainer bucket and pan. Wash and rinse them thoroughly

Clean the pump cover with a soft cloth or brush. Do not allow food soil to accumulate on the tank bottom or to enter the drain

Remove the overflow tube (does not apply to AM15SVL or AM15SVLT models). Wash and rinse the overflow tube inside and out

On AM15SVL and AM15SVLT models, remove the pumped drain sreen; wash and rinse inside and out

FOR MODELS AM15VL, AM15SVL, AM15VLF, AM15VLT AND AM15SVLT

Disconnect the electrical power to the machine (both dishwasher and booster if applicable) and follow lockout/tagout procedures. Be sure all circuits are disconnected.

Nut from each baffle loosened and removed

Baffles removed by sliding the tab out of the retainer

Debris washed from top surfaces of baffles with a mild detergent and rinsed

Front baffle replaced with the back side on the outside of the duct lip on the chamber top

Machine door left open to allow interior to air out and dry

Sign off on the dishwasher cleaning

WARNING: Disconnect the electrical power to the machine (both dishwasher and booster if applicable) and follow lockout / tagout procedures. Be sure all circuits are disconnected.

Upper and lower wash and rinse arms (page 33, Figs. 39, 40) should turn freely and continue turning for a few seconds after being whirled by hand. To check, rotate arms and remove any obstructions causing improper operation.

If either the strainer pan or the strainer bucket is not properly in place, obstructions (such as food particles or bones) may clog the wash arm nozzles. The wash arms are easily removed for cleaning.

To remove the lower wash arm, unscrew the hand knob and lift the rinse arm off (Fig. 39). The wash arm can be lifted off once the rinse arm is removed.

The upper wash and rinse arms are removed by unscrewing the hand knob (Fig. 40) and lowering both arms together. Be careful not to drop these arms.;