ENERSYS SCR Transformer Type Battery Charger SLTC2

Return all replaced components to your service center.

The following sections explain how to replace each component. After replacing a component, be sure to: Reconnect all leads exactly as they were removed, Replace any heat-shrink tubing if any old tubing was removed, Retighten all connections, Replace covers.

Use an anti-static wrist strap (i.e. EnerSys part number 174-2-1) when handling, removing and replacing circuit board assemblies.

Return all replaced components to your service center.

The following sections explain how to replace each component. After replacing a component, be sure to:

1. Reconnect all leads exactly as they were removed,

2. Replace any heat-shrink tubing if any old tubing was removed,

Please follow these steps before removing or replacing any component:

Please follow these steps before removing or replacing an EPROM:

Follow these steps to remove the EPROM. (Be sure your hands are fairly clean before touching a PC board.)

3. Touch your finger to a ground to discharge static.

Return all replaced components to your service center.

The following sections explain how to replace each component. After replacing a component, be sure to:

1. Reconnect all leads exactly as they were removed,

2. Replace any heat-shrink tubing if any old tubing was removed,

Please follow these steps before removing or replacing any component:

Please follow these steps before testing the contactor:

On Connector J3, on the PC board,

2. The contactor should pull in.

3. If it does not, check the wiring from Connector J3 to the fuse and to the contactor.