Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.

Documents & Manuals

Find all the essential guides in one place.

Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more

Work Order Templates

Pre-built workflows to keep your asset running smoothly.

Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more

Procedures

Integrate maintenance plans directly into your work orders.

Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more

Parts

Access the parts list for your equipment in MaintainX.

Drive Motor
B2 Rollers
Tensioning System
+ 40 more

Doosan Forklift G33P-7

Create an account to install this asset package.

Maintenance Plans for Doosan Forklift Model G33P-7

Integrate maintenance plans directly into your work orders in MaintainX.

1000 Hourly / 6 Monthly Forklift Maintenance

Hydraulic Return Filter, Breather & Strainer - Check, Change

Steps to change Hydraulic Return Filter, Breather & Strainer

Transmission Oil, Oil Filter & Strainer - Check, Clean, Change

Lift Chains - Test, Check, Adjust

Lift Chain Wear Test

Check for Equal Tension

Lift Chain Adjustment

Universal Joint – Inspect

Universal Joint Inspection

Run this procedure

200 Hourly Regulator Tar Draining

Warning: This procedure should be performed every 200 hours.

Engine started and warmed up using LPG

Tank cock closed and LPG in fuel line consumed

Drain plug removed and tar drained from LP regulator (vaporizer)

Tray placed below to prevent engine room from getting dirty

Sealant applied to drain plug and assembled after finishing work

Sign off on the tar draining procedure

Run this procedure

2500 Hourly / 15 Monthly Forklift Maintenance

Every 2500 Service Hours or 15 Months

You must read and understand the warnings and instructions contained in the Safety section of this manual, before performing any operation or maintenance procedures.

1) Hydraulic Oil - Check, Clean, Change

WARNING

Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin.

Park the lift truck level with the forks lowered, parking brake engaged, transmission in NEUTRAL and the engine stopped.

Remove the hydraulic tank drain plug. Allow the oil to drain into a suitable container. Clean and install the plug.

Remove the dipstick/filter cap assembly.

Fill the hydraulic tank.

Run this procedure

250 Hourly / 1 Monthly Forklift Maintenance

Safety Warning: Read and understand the warnings and instructions contained in the Safety section of this manual, before performing any operation or maintenance procedures.

Engine Oil & Filter (G424P(E) Engine Only) - Change

Gasoline, LP Engine Crankcase

NOTICE: Engine Oil Service hours can be extended to 500 hours by using Doosan supplied specific oil. Please consult Doosan dealer about it.

Sign off on the forklift maintenance

Run this procedure

10 Hourly / 1 Daily Forklift Inspection

Visually inspect forks for cracks, especially in the heel section, around the mounting brackets, and all weld areas.

Inspect for broken or jagged fork tips, bent or twisted blades and shanks.

Make sure positioning lock is in place and working.

Lock the forks in position before using the truck.

Remove all defective forks from service.

Inspect Engine for Fluid Leaks