Daikin Outdoor Unit Cooling Only Air Conditioner RKS24JV2S

Warning: Wait for 10 minutes after turning off all power supplies before disassembling work.

Remove the screw on the stop valve mounting plate.

Remove the screw on the partition plate (1).

Remove the 2 screws to detach the earth / ground wires.

Disconnect the connector [S70] (fan motor).

Release the fan motor lead wire from the 5 hooks.

Disconnect the connectors of the front side: [S20] (electronic expansion valve coil), [S40] (overload protector), [S80] (four way valve coil), [S90] (thermistors).

Ensure all power supplies are turned off for at least 10 minutes before starting disassembly

Pull out the electronic expansion valve coil

Remove the screw and remove the four way valve coil (if applicable)

Pull out the outdoor heat exchanger thermistor

Ensure the clip for the thermistor is not lost

Remove the discharge pipe thermistor

Wait for 10 minutes after turning off all power supplies before disassembling work.

Ensure no burns from heated pipes and parts.

Ventilate the room if refrigerant gas leaks during work.

Prepare wet cloth to extinguish fire immediately if refrigerant oil catches fire.

Environmental and Safety Cautions

Do not discharge refrigerant gas into the atmosphere. Collect all refrigerant gas.

Restore piping by non-oxidation brazing.

Ensure all power supplies are turned off for at least 10 minutes before starting disassembly

Lift the top panel and remove it

Warning: Wait for 10 minutes or more after turning off all power supplies before disassembling work.

Remove the sound blanket (top upper)

Remove the screw and slightly push the partition plate (1) to the left for easy work

Remove the sound blanket (outer)

Design of sound blankets varies depending on the model

Sound blanket is fragile. Carefully pass the discharge pipe through it

Since the piping ports are torn easily, remove the sound blanket carefully

Remove the sound blanket (top lower)