Bunn Dispenser JDF-2S, VPDS

Remove all concentrate from the dispenser and store in a separate refrigerated compartment

Fill clean empty concentrate container(s) with approximately 32 oz. (946 ml) of hot tap water (approximately 140 Deg F (60 Deg. C). Load the containers of hot water into the dispenser (just like concentrate)

Place an empty container under the dispense nozzles

Press and hold the dispense button at each station until the stream out of the nozzles runs clear (about 30 seconds)

Once this is completed, remove the container(s) and empty

Remove each dispense nozzle and mixing element and run under hot tap water to remove excess pulp

Prepare 2.5 gal. (9.46 L) of sanitizing solution

Place nozzle(s) and mixing elements) in a separate 1-quart container of sanitizing solutions and mix thoroughly. Allow the parts to soak for 2 minutes

Clean the dispense nozzle receptacle(s) (dispense valves) with the sanitizing solution and a soft bristle brush

1. Remove and wash the dispense nozzle(s), drip tray and drip tray cover in a mild detergent solution. Rinse thoroughly

Use brush (00674.0000) to clean inside and oring area on dispense nozzles

2. Wipe splash panel, areas around dispense nozzle(s), and refrigerated compartment with a clean, damp cloth

3. Use brush and a mild detergent solution to clean inside dispense area where dispense nozzles are removed. Rinse;

- Clean Condenser Coils and Filter

1. Removable filter can be cleaned in warm soapy water

2. Use a soft bristle brush to clean the build up of dirt in the condenser

- Check water level in ice bath Annually. Top off if needed

39690.0000 Tube Kit JDF-2S & JDF-4S

2. Remove all product containers and place them in a refrigerated (35-40 degrees F [1.6-4.4 degrees C]) environment. Disconnect all connections to ambient products from the bottle adapter

Tools required: 32 oz. (946 ml) minimum empty container

Open dispenser door. Lift up on product containers and remove them from the machine

Close the door, place an empty container under the dispensing nozzle

Dispense from each station until clear water flows from the dispense nozzle

Open dispenser door and reconnect all product containers

Sign off on the dispenser cleaning