Bunn Brewer AXIOM-DV

Warning: Use a damp cloth rinsed in any mild, nonabrasive, liquid detergent for cleaning all surfaces on Bunn-O-Matic equipment

Insert the short end of the sprayhead cleaning tool into each of the five water outlets of the plastic sprayhead to remove any mineral deposits

Insert the long end of sprayhead cleaning tool into the sprayhead fitting, and rotate several times to remove any mineral deposits from the fitting

Note: In hard water areas, this may need to be done daily. It will help prevent liming problems in the brewer and takes less than a minute

Note: In the event that the 'Brew Logic' circuit activates (compensating for high lime build up), it will temporarily disable the 'Recovery Booster' and 'Pulse Brewing' systems until the unit has been de-limed

Sign off on the daily brewer cleaning

Loosen screws that secure the front access panel. Remove the panel

Fasten the white hose shutoff clamp at the end of the drain hose

Unfasten the black hose clamp at the end of the drain hose (above solenoid, or above check valve if equipped)

Place the end of the drain hose in a container that has a minimum capacity of 200 oz (5.9 L)

Release the white clamp to drain water from the tank

When tank is empty, leave the white clamp loose, and tighten the black clamp at the end of the drain hose. (Repeat steps 2-6 for remaining side on Twins)

Replace the front panel and tighten screws

Sign off on the Brewer Tank Maintenance