Branson Ultrasonics Ultrasonic Vapor Degreaser B3550

Warning: Follow local regulations for disposal of residue.

Separator/desiccator is set as a separator (desiccator bag not installed)?

If desiccator bag is installed, remove it before proceeding.

Water separator water drain opened?

Collect the discharge into a container.

Water separator water drain closed after flow stops?

Describe the appearance of the residue.

Sign off on the daily separator cleaning

Warning: Ensure the pump motors are turned off before starting the lubrication process.

Enter the amount of machine oil used for lubrication

Does the vertical air cylinder require mineral oil?

Enter the amount of mineral oil used if any

Is an air lubricator used on the incoming air supply?

Lift raised to the fully up position?

Warning: Disconnect the degreaser from electrical power before starting the procedure.

Degreaser disconnected from electrical power?

To replace the control or relay board

All wires transferred to the new board?

New board installed and screws reinstalled?

Voltage Switch (SW1) placed in the 230V position?

Is the CONTAMINATION WARNING Indicator lighted but the degreaser has not shut down on B/S TEMP FAULT?

Remove 2-3 inches of solvent from the ultrasonic sump.

Is the ultrasonic sump heater exposed?

Is the solvent starting to overflow into the boil sump?

Has the degreaser shut down on B/S TEMP FAULT or B/S LEVEL FAULT?

Drain the solvent from the boil sump.

Refill the degreaser using the solvent removed in the first step. Add solvent as required.

Warning: This inspection requires trained personnel with PPE!

Check for loosening of plumbing connections

Check for leaks in solvent systems

Check for dampness or cold spots caused by evaporative cooling

Choose the method used for leak detection

Note any issues found during the inspection

Sign off on the degreaser inspection