Branson Ultrasonics Ultrasonic Vapor Degreaser B950R

Warning: Follow local regulations for disposal of residue.

Separator/desiccator bag removed?

If not, remove the desiccator bag before proceeding.

Water separator water drain opened?

If not, open the water separator water drain.

Upload a photo of the collected discharge in a container.

If not, wait until the flow stops.

Water separator water drain closed?

Lubricate pump motors with machine oil every 6 months.

The vertical air cylinder may occasionally require a few drops of mineral oil to lubricate the seals. Add lubricant if the lift lowers from an intermediate held position.

An air lubricator may be used on the incoming air supply. Oil residues will be discharged from the solenoid valve exhaust ports. The mufflers may be replaced by hoses exhausting to an oil trap to prevent oil accumulations or oil mists within the degreaser enclosure.

The cylinder may be lubricated directly:

• Raise the lift to the fully up position

• Remove the top exhaust flow control valve

• Place one or two squirts from an oil can into the port

• Replace the flow control valve and air hose

Warning: Disconnect the degreaser from electrical power before starting the procedure.

Degreaser disconnected from electrical power?

To replace the control or relay board

All wires transferred to the new board?

New board installed and screws reinstalled?

Voltage Switch (SW1) placed in the 230V position?

Is the CONTAMINATION WARNING Indicator lighted but the degreaser has not shut down on B/S TEMP FAULT?

Remove 2-3 inches of solvent from the ultrasonic sump.

Is the ultrasonic sump heater exposed?

Is the degreaser boiling until it shuts down on B/S TEMP FAULT or B/S LEVEL FAULT?

Drain the solvent from the boil sump.

Refill the degreaser using the solvent removed in the first step. Add solvent as required.

Warning: This inspection requires trained personnel with PPE!

If leaks are detected, report to the maintenance team immediately

Check for dampness or cold spots caused by evaporative cooling

Choose the method used for leak detection

Note any issues found during the inspection

Sign off on the degreaser inspection