Branson Ultrasonics Ultrasonic Vapor Degreaser B452R

Warning: Follow local regulations for disposal of residue.

Draining Water From Water Separator

Open the water separator water drain and collect the discharge into a container.

Sign off on the separator cleaning

Lubricate pump motors with machine oil every 6 months.

The vertical air cylinder may occasionally require a few drops of mineral oil to lubricate the seals. Add lubricant if the lift lowers from an intermediate held position.

An air lubricator may be used on the incoming air supply. Oil residues will be discharged from the solenoid valve exhaust ports. The mufflers may be replaced by hoses exhausting to an oil trap to prevent oil accumulations or oil mists within the degreaser enclosure.

The cylinder may be lubricated directly:

• Raise the lift to the fully up position

• Remove the top exhaust flow control valve

• Place one or two squirts from an oil can into the port

• Replace the flow control valve and air hose

Warning: Disconnect the degreaser from electrical power before starting the procedure.

Degreaser disconnected from electrical power?

To replace the control or relay board

All wires transferred to the new board?

New board replaced and screws reinstalled?

Voltage Switch (SW1) placed in the 230V position?

Is the CONTAMINATION WARNING Indicator lighted but the degreaser has not shut down on B/S TEMP FAULT?

Remove 2-3 inches of solvent from the ultrasonic sump.

Did the degreaser shut down on B/S TEMP FAULT or B/S LEVEL FAULT?

Drain the solvent from the boil sump.

Refill the degreaser using the solvent removed in the first step. Add solvent as required.

Did you operate the degreaser for at least 4 hours to purify the solvent in the ultrasonic sump?

Did you shut off and lock out electrical power?

Warning: This inspection requires trained personnel with PPE!

Check all plumbing connections for looseness

Check for dampness or cold spots caused by evaporative cooling

Choose the method used for leak detection

Order number for electronic leak detector if used

Pass the leak detector’s sensor around all plumbing joints and tank seams

Sign off on the degreaser inspection